Extended versions of papers presented at the 5th International and 26th All India Manufacturing
Technology, Design and Research (AIMTDR) Conference.
- Experimental assessment on performance of TiN/TiCN/Al2O3/ZrCN coated tool during dry machining of Nimonic C-263
- Comparative evaluations of nose wear progression and failure modes during hard turning under dry and near-dry cutting conditions
- Effect of tool wear on white layer thickness and subsurface hardness on hard turned EN31 steel
- Experimental investigation on cutting force and surface roughness in machining of hardened AISI 52100 steel using cBN tool
- Experimental comparative study of conventional, micro-textured and coated micro-textured tools during machining of hardened AISI 1040 alloy steel
- An experimental study of cutting forces and temperature in multi-tool turning of grey cast iron
- Determining cutting force coefficients from instantaneous cutting forces in ball end milling
- Effect of process parameters on convective heat transfer coefficient of fluid and heat partitioning in high efficiency deep grinding with water-based coolant
- An alternate method for optimisation of minimum quantity lubrication parameters in surface grinding
- Study on fluctuation of cutting force in process of high-speed milling of Inconel 718
- Study of the local forces along a cutting edge when drilling Ti6Al4V - comparison of methods
- Study of finish milling of titanium alloy (TI6AL4V)
No comments:
Post a Comment